From checking seat belt operation to the exhaust system; brake pipes to suspension springs - our comprehensive Full Service gives your car some serious TLC. We’ll also replace the engine oil, oil filter, engine air filter (and where applicable points and condenser), top up fluids and we’ll lubricate grease nipples.
WE’LL REPLACE
- Engine oil
- Oil filter
- Engine air filter
- We’ll top up fluids and lubricate grease nipples (where needed)
- Everything is checked from seat belt operation to the exhaust system.
FULL SERVICE + MOT WORK SCHEDULE
No additional work will be carried out without prior approval
- Check lights, side, reverse, no. plate, fog, brake, tail, indicators, headlights, repeaters, reactors, and hazards
- Check number plate condition
- Check fuel cap condition
- Check horn operation
- Check ABS warning light for correct operation
- Check heater plug indicator (Diesel)
- Check seat belts front and rear (inc. lap belt)
- Check windscreen wiper blade condition
- Check washer operation (front and rear)
- Check shock absorbers (bounce test)
- Check tyre wear and record measurements
- Lubricate accessible door hinges
UNDER THE BONNET
- Renew air filter if required
- Remove and check pollen filter condition (additional cost)
- Replace pollen filter (additional cost)
- Check and top-up brake fluid
- Replace brake fluid every 2 years (additional cost)
- Screen and headlight washer reservoir, check and top-up
- Power steering reservoir. Top-up if required
- Check cooling fan for operation (where applicable)
- Check and top up antifreeze/coolant
- Drain and replace coolant if due
- Visual check of hoses & pipes for condition (where visible)
- Check battery clean & grease terminals & check voltage
- Visual inspection of drive belts (adjust where applicable)
- Check timing/cam belt replacement (report if due)
- Lubricate bonnet latch and hinge
VEHICLE RAISED
- Renew engine oil (synthetic & specialist oils at extra charge)
- Replace oil filter
- Run engine and check for engine and gear box oil leaks
- Refit sump plug
- Check wheel bearings for play and noise
- Check steering components for wear, corrosion and leaks
- Visually inspect brakes where visible
- Visually inspect brake system hydraulics for leaks & corrosion
- Check brake servo operation
- Check handbrake operation and adjust if needed
- Inspect and report on exhaust system
- Inspect front wheel cylinders/callipers for leaks and operation
- Check and record tyre pressures for all 5 tyres
- Check propshaft/drive shaft, joints and gaiters for security and condition
- Check suspension springs
- Check shock absorbers
ROAD TEST
- Check gear box operation
- Check engine noise
- Check clutch operation
- Check for excessive exhaust smoke
- Check steering operation
AFTER ROAD TEST
- Recheck engine oil levels
- Check wheel nut torque settings and adjust if needed
- Stamp service book if available